Marine Grade Heat Shrink Tubing with Adhesive Lining, 3:1 - Red, 12.7 mm Diameter

This red marine grade heat shrink tubing has a 12.7 mm diameter that shrinks down to 4.2 mm, giving wire joins, connectors and cable ends a tight, insulated seal. The 3:1 shrink ratio and the glue liner inside the double wall help bond and protect the cable. A 12.7 mm bore fits standard wire harnesses, connector ends and cable repairs.

Features

• Shrinks from 12.7 mm to 4.2 mm for a snug fit around the cable.
• Glue liner inside a double wall adds a moisture-resistant seal, handy where corrosion protection and long-lasting sealing matter.
• Shrinks quickly at a low temperature, so heating takes very little time.
• Flame retardant polyolefin that stays flexible and gives good electrical insulation.
• Suits wire joins, connector end-handling, wire harnesses, antennas and corrosion protection of metal rods or tubes.
• Cuts to length with scissors or a sharp knife.

Specifications

• Colour: Red
• Size: 12.7 mm diameter (4.2 mm after shrinking)
• Shrink ratio: 3:1
• Material: Polyolefin
• Wall: Double wall with glue liner
• Minimum shrink temperature: 70 °C
• Full shrink temperature: 110 °C maximum
• Operating temperature: -55 °C to 125 °C
• Tensile strength: 10.4 MPa
• Dielectric strength: 15 kV/mm
• Flammability: Flame retardant
• Supplied: Flat

Package includes

• 1 x red adhesive-lined heat shrink tubing (12.7 mm diameter)